A.going„„stealing
B.going„stole
C.went„stealing
D.went„stole
Peter's jacket looked just the same as Jack’S，but it cost____________his．A．as much twice asB．twice as much asC．much as twice asD．as twice much as
点击查看答案
3．—Who's ________friend? ．—His friend is Mike．A．yourB．myC．herD．his
( )knowledge of space developed rapidly.A、Person’sB、Mens’C、Men'sD、Man’s
Which set of configuration commands configures MBGP on the ERX Edge Router?()A. router bgp 100 neighbor 192.168.10.1 remote-as 200 address-family ipv4 multicast neighbor 192.168.10.1 next-hop-selfB. router bgp 100 neighbor 192.168.10.1 remote-as 200 address-family vpnv4 multicast neighbor 192.168.10.1 activateC. router bgp 100 neighbor 192.168.10.1 remote-as 200 address-family ipv4 unicast neighbor 192.168.10.1 activeD. router bgp 100 neighbor 192.168.10.1 remote-as 200 address-family ipv4 multicast neighbor 192.168.10.1 activate
Which configuration command establishes an EBGP session to a peer in AS 300?()A. neighbor 200.16.1.2 remote-as 300B. bgp-neighbor 200.16.1.2 remote-as 300C. ebgp-neighbor 200.16.1.2 remote-as 300D. neighbor 200.16.1.2 remote-as 300 connection-type ebgp
R1 in ASN 1 with loopback1 address 1.1.1.1 needs to be configured with an iBGP connection to R2 with loopback2 IP address 2.2.2.2. The connection should use the loopbacks.Which o f the following commands is required on R1?（）A. neighbor 1.1.1.1 remote- as 1B. neighbor 2.2.2.2 remote- as 2C. neighbor 2.2.2.2 update - source loopback1D. neighbor 2.2.2.2 ibgp -multihop 2E. neighbor 2.2.2.2 ibgp - mode
Refer to the exhibit. Two routers are connected by Frame Relay and are running OSPF bet ween them. Each router has been configured with the appropriate network statements under router ospf 1, but the routers are not forming an adjacency. Which of the following three commands could be configured on each router to correct this problem?（）A. RouterC(config - if)#ip ospf network broadcast RouterD(config - if)#ip ospf network broadcastB. RouterC(config - if)#ip ospf network point - to - point RouterD(config - if)#ip ospf network point - to - pointC. RouterC(config - router)#neighbor 10.100. 100.4 RouterD(config - router)#neighbor 10.100.100.3D. RouterC(config - router)#neighbor 10.255.255.254 RouterD(config - router)#neighbor 10.255.255.253
