A network administrator needs to allow only one Telnet connection to a router. For anyone viewing the configuration and issuing the show run command, the password for Telnet access should be encrypted. Which set of commands will accomplish this task?（）A.B - 搜题匠

违法和不良信息举报联系客服

免费注册登录

题目内容(请给出正确答案)

A network administrator needs to allow only one Telnet connection to a router. For anyone viewing the configuration and issuing the show run command, the password for Telnet access should be encrypted. Which set of commands will accomplish this task?（）

A.

B.

C.

D.

如果没有搜索结果或未解决您的问题，请直接联系老师获取答案。

更多相关问题

第1题

A network administrator has configured source NAT, translating to an address that is on a locally connected subnet.The administrator sees the translation working, but traffic does not appear to come back.What is causing the problem?（）A. The host needs to open the telnet port.B. The host needs a route for the translated address.C. The administrator must use a proxy-arp policy for the translated address.D. The administrator must use a security policy, which will allow communication between the zones.

点击查看答案
第2题

A network administrator needs to configure a router for a Frame Relay connection to a non－Cisco router. Which of the following commands will prepare the WAN interface for this connection?()A. Router(config-if)# encapsulation frame-relay q933aB. Router(config-if)# encapsulation frame-relay ansiC. Router(config-if)# encapsulation frame-relay ietfD. Router(config-if)# encapsulation frame-relay islE. None of the above

点击查看答案
第3题

The network administrator needs to address seven LANs. RIP version 1 is the only routing protocol in use on the network and subnet 0 is not being used. What is the maximum number of usable IP addresses that can be supported on each LAN if the organization is using one class C address block?（）A.8B.6C.30D.32E.14F.16

点击查看答案
第4题

A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-Cisco router.How should the network administrator configure the serial interface of the main office router to make the connection?（）A.B.C.D.

点击查看答案
第5题

When one connection to a host fails in a full mesh network， which of the following is true？（）A、All hosts can communicate.B、No hosts can communicate.C、Half of the hosts will lose communication.D、Only the two hosts between the failed connection will lose communication.

点击查看答案
第6题

Refer to the exhibit. A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes the output from these two show commands.Which two of these changes are necessary for SwitchA to meet the requirements? （）A、Port security needs to be globally enabled.B、Port security needs to be enabled on the interface.C、Port security needs to be configured to shut down the interface in the event of a violation.D、Port security needs to be configured to allow only one learned MAC address.E、Port security interface counters need to be cleared before using the show command.F、The port security configuration needs to be saved to NVRAM before it can become active.

点击查看答案
第7题

A network administrator needs to add an additional connection to a room. The administrator adds a new Ethernet switch and must connect it to an existing switch. Which cable type should be used to connect the two switches?（）A、CAT3 cableB、Serial cableC、Crossover cableD、Rollover cable

点击查看答案

相关内容