A. The Boot IOS Code is Located in the NVRAM.
B. Check NVRAM for boot system Commands.
C. Bypass NVRAM Configurations.
D. Boot the IOS Code Located in ROM.
E. Perform a Password Recovery.
F. Bypass The Code In ROM.
单选题What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? （）A 0x2100B 0x2101C 0x2102D 0x2124E 0x2142
点击查看答案
单选题A cisco router is booting and has just completed the POST process.It is now ready to find and load an IOS image.what function does the router perform next?（）A It checks the configuration registerB It attempts to boot from a TFTP serverC It loads the first image file in flash memoryD It inspects the configuration file in NVRAM for boot instructions
单选题A cisco router is booting and has just completed the POST process.It is now ready to find and load an IOSimage.what function does the router perform next?（）A It checks the configuration registerB It attempts to boot from a TFTP serverC It loads the first image file in flash memoryD It inspects the configuration file in NVRAM for boot instructions
单选题In PIM-SM operations，to which device does the first router that connects with the multicast source sendthe register message？（）A RPB multicast sourceC IGMP routerD multicast receiverE PIM designated router
多选题A network administrator changes the configuration register to 0x2142 and reboots the router. What are two results of making this change?（）AThe IOS image will be ignored.BThe router will prompt to enter initial configuration mode.CThe router will boot to ROM.DAny configuration entries in NVRAM will be ignored.EThe configuration in flash memory will be booted.
单选题What does a configuration Register Setting of 0x2105 indicate to the Router? （）A The Boot IOS Code is Located in the NVRAM.B Check NVRAM for boot system Commands.C Bypass NVRAM Configurations.D Boot the IOS Code Located in ROM.E Perform a Password Recovery.F Bypass The Code In ROM.
单选题Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enter the system configuration dialog as shown. What is the caust of the problem?（）AThe network administrator faled to save the configuration.BThe configuration register is set to 0x2100.CThe boot system flash command is missing from the configuration.DThe configuraiton register is set to 0x2102.EThe router is configured with the boot system startup command.
